FRONT SEAT INNER BELT ASSEMBLY REMOVAL

Info Added 2017-10-06

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the front seat inner belt assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replacement Part or Procedure	Necessary Procedure	Effect/Inoperative when not Performed	Link
Disconnect cable from negative auxiliary battery terminal	Memorize steering angle neutral point	Lane departure alert system (w/ Steering Control)	Click here
		Simple intelligent parking assist system*1
		Toyota parking assist-sensor system*1
		Pre-collision system
	Initialize back door lock	Power door lock control system	Click here

*1: When performing learning using the GTS.

Click here

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click here
Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips

Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the driver side and front passenger side.
The procedure listed below is for the driver side.

PROCEDURE

REMOVE FRONT SEAT ASSEMBLY

Click here
REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Driver Side)
1. Disengage the clamp and claw.
2. w/ Vertical Adjuster:
  1. Disengage the clamps.
  2. Remove the nut and front seat inner belt assembly.
3. w/o Vertical Adjuster:
  1. Disengage the clamp.
  2. Remove the nut and front seat inner belt assembly.
4. Remove the front seat belt anchor plate.
REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Front Passenger Side)
1. Disconnect the connector.
2. Disengage the clamps and claw.
3. Disengage the clamp.
4. Remove the nut and front seat inner belt assembly.
5. Remove the front seat belt anchor plate.