SEAT POSITION SENSOR REMOVAL

Info Added 2017-10-06

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the seat position airbag sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Simple intelligent parking assist system*1
Toyota parking assist-sensor system*1
Pre-collision system
Initialize back door lock Power door lock control system

Click here

*1: When performing learning using the GTS.

Click here

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The following procedure is for LHD vehicles.

PROCEDURE


  1. REMOVE FRONT SEAT ASSEMBLY

    Click here

  2. REMOVE SEAT SLIDE POSITION SENSOR PROTECTOR


    1. A001QVC

      Disengage the clamp and disconnect the connector.

    2. A001QKUC01
      B0048R7 Remove in this Direction (1)
      B0048O3 Remove in this Direction (2)

      Pull the seat slide position sensor protector in the direction indicated by the arrow (1), to disengage the pin, and then slide the seat slide position sensor protector in the direction indicated by the arrows (2) shown in the illustration to remove it.

  3. REMOVE SEAT POSITION AIRBAG SENSOR (for 6 Way Seat Type)


    1. A001PAX

      Using a T30 "TORX" socket wrench, remove the "TORX" bolt and seat position airbag sensor.

  4. REMOVE SEAT POSITION AIRBAG SENSOR (for 4 Way Seat Type)


    1. A001Q5H

      Remove the nut and seat position airbag sensor.