FRONT SEAT SIDE AIRBAG ASSEMBLY REMOVAL

Info Added 2017-10-06

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front seat airbag assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure	Necessary Procedure	Effect/Inoperative when not Performed	Link
Disconnect cable from negative auxiliary battery terminal	Memorize steering angle neutral point	Lane departure alert system (w/ Steering Control)	Click here
		Simple intelligent parking assist system*1
		Toyota parking assist-sensor system*1
		Pre-collision system
	Initialize back door lock	Power door lock control system	Click here

*1: When performing learning using the GTS.

Click here

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click here
Wear protective gloves. Sharp areas on the parts may injure your hands.

Note

If a front seat airbag assembly has been deployed, replace the front seat airbag assembly, front seatback frame sub-assembly, separate type front seatback pad and separate type front seatback cover with the necessary parts in accordance with the extent of the collision damage.

Tech Tips

Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the driver side and front passenger side.
The procedure listed below is for the driver side.

PROCEDURE

REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD

Click here
REMOVE FRONT SEAT AIRBAG ASSEMBLY
CAUTION:

When storing the front seat airbag assembly, keep the airbag deployment side facing upward.

Deployment Side
1. Disengage the clamp.
2. Remove the 2 nuts and front seat airbag assembly.
  Note
  - Do not reuse the nuts.
  - Make sure that the front seatback frame sub-assembly is not deformed. If it is deformed, replace it with a new one.