PERSONAL LIGHT INSPECTION

PROCEDURE


  1. INSPECT MAP LIGHT ASSEMBLY


    1. A001OY9C01
      *a

      Component without harness connected

      (Map Light Assembly)

      Check the map light.


      1. Apply auxiliary battery voltage to the map light assembly and check that the map light comes on.

        OK
        Auxiliary battery Connection Switch Condition Specified Condition

        Auxiliary battery positive (+) → 12 (+B1)

        Auxiliary battery negative (-) → 3 (GND)

        		 Map light switch LH on Map light LH comes on
        Map light switch LH off Map light LH does not come on
        Map light switch RH on Map light RH comes on
        Map light switch RH off Map light RH does not come on

        Auxiliary battery positive (+) → 12 (+B1)

        Auxiliary battery negative (-) → 10 (DOOR)

        		 Map light switch off and door switch on Map light comes on
        Map light switch off and door switch off Map light does not come on

        If the result is not as specified, replace the map light bulb or map light assembly.

    2. Check the door switch.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Switch Condition Specified Condition
        10 (DOOR) - 4 (RLMP) Door switch on Below 1 Ω
        Door switch off 10 kΩ or higher

        If the result is not as specified, replace the map light assembly.

    3. Check the switch illumination.


      1. Apply auxiliary battery voltage to the map light assembly and check that the illumination comes on.

        OK
        Auxiliary battery Connection Specified Condition

        Auxiliary battery positive (+) → 2 (ILLB)

        Auxiliary battery negative (-) → 3 (GND)

        		 Illumination comes on

        If the result is not as specified, replace the map light assembly.