2ZR-FXE AUXILIARY BATTERY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the auxiliary battery removal/installation are shown below.

*1: When performing learning using the GTS.
Click here Click here

PROCEDURE

1. PRECAUTION

   Note

   
   

   • After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

     Click here

   • When replacing the auxiliary battery, use a new auxiliary battery of the same dimensions with a capacity of 51 Ah or more at a 20-hour rate.

2. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

   
   

   1. 

      Loosen the nut and disconnect the cable from the negative (-) auxiliary battery terminal.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

      Click here

3. REMOVE AUXILIARY BATTERY

   
   

   1. Disengage the 2 claws and open the battery terminal cap in the order shown in the illustration.

      

      *a	Top View of Claws	-	-
      	Push Battery Terminal Cap Here		Push
      	Open	-	-

   2. 

      Loosen the nut and disconnect the cable from the positive (+) auxiliary battery terminal.

   3. 

      Remove the battery insulator from the auxiliary battery.

   4. 

      Remove the bolt and battery clamp No. 2.

   5. 

      Remove the auxiliary battery from the vehicle.