2ZR-FXE SPARK PLUG REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during ignition coil assembly or spark plug removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

  • Replacement of ignition coil assembly

  • Replacement of spark plug

 Inspection After Repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here

PROCEDURE


  1. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

    Click here

  2. REMOVE NO. 1 HEATER AIR DUCT SPLASH SHIELD SEAL

    Click here

  3. REMOVE WATER GUARD PLATE LH

    Click here

  4. REMOVE COWL BODY MOUNTING REINFORCEMENT LH

    Click here

  5. REMOVE COWL BODY MOUNTING REINFORCEMENT RH

    Click here

  6. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD)

    Click here

  7. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)

    Click here

  8. REMOVE IGNITION COIL ASSEMBLY

    Click here

  9. REMOVE SPARK PLUG


    1. A001QEF

      Remove the 4 spark plugs from the cylinder head sub-assembly.

      Note

      If a spark plug has been struck or dropped, replace it.

      Tech Tips

      Arrange the removed parts in the correct order.