TRIP SWITCH INSPECTION

PROCEDURE


  1. INSPECT TRIP SWITCH

    A01W4Y8E07
    Text in Illustration
    *a

    Component without harness connected

    (Trip Switch)

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      2 (A/B) - 5 (E) ODO/TRIP switch not pressed 10 kΩ or higher
      ODO/TRIP switch pressed Below 1 Ω
      3 (IG) - 5 (E) Light control rheostat up switch not pressed 10 kΩ or higher
      Light control rheostat up switch pressed Below 1 Ω
      3 (IG) - 5 (E) Light control rheostat down switch not pressed 10 kΩ or higher
      Light control rheostat down switch pressed Below 1 Ω

    2. Apply battery voltage to the terminals of the switch, and check the lighting condition of the trip switch.

      OK
      Measurement Condition Condition Specified Condition

      Battery positive (+) → 8 (ILL+)

      Battery negative (-) → 6 (ILL-)

      		 Always Trip switch illumination comes on

      If the result is not as specified, replace the trip switch.