REAR DOOR LOCK INSPECTION

PROCEDURE


  1. INSPECT REAR DOOR LOCK ASSEMBLY LH


    1. A01W2F1E10
      Text in Illustration
      *a

      Component without harness connected

      (Rear Door Lock Assembly LH)
      *b Unlock
      *c Lock

      Check the operation of the door lock motor.


      1. Apply battery voltage and check the operation of the door lock motor.

        OK
        Connection Result

        Battery positive (+) → Terminal 4 (L)

        Battery negative (-) → Terminal 1 (UL)

        		 Locks

        Battery positive (+) → Terminal 1 (UL)

        Battery negative (-) → Terminal 4 (L)

        		 Unlocks

        If the result is not as specified, replace the rear door lock assembly LH.

    2. A01W2F1E11
      Text in Illustration
      *a

      Component without harness connected

      (Rear Door Lock Assembly LH)
      *b Unlock
      *c Lock

      Check the operation of the unlock detection switch.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        6 (LSSR) - 9 (E) Locked 10 kΩ or higher
        6 (LSSR) - 9 (E) Unlocked Below 1 Ω

        If the result is not as specified, replace the rear door lock assembly LH.

  2. INSPECT REAR DOOR LOCK ASSEMBLY RH


    1. A01W39BE09
      Text in Illustration
      *a

      Component without harness connected

      (Rear Door Lock Assembly RH)
      *b Unlock
      *c Lock

      Check the operation of the door lock motor.


      1. Apply battery voltage and check the operation of the door lock motor.

        OK
        Connection Result

        Battery positive (+) → Terminal 4 (L)

        Battery negative (-) → Terminal 1 (UL)

        		 Locks

        Battery positive (+) → Terminal 1 (UL)

        Battery negative (-) → Terminal 4 (L)

        		 Unlocks

        If the result is not as specified, replace the rear door lock assembly RH.

    2. A01W39BE10
      Text in Illustration
      *a

      Component without harness connected

      (Rear Door Lock Assembly RH)
      *b Unlock
      *c Lock

      Check the operation of the unlock detection switch.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        6 (LSSR) - 9 (E) Locked 10 kΩ or higher
        6 (LSSR) - 9 (E) Unlocked Below 1 Ω

        If the result is not as specified, replace the rear door lock assembly RH.