LEXUS PARKING ASSIST-SENSOR SYSTEM Clearance Warning ECU Power Source Circuit

DESCRIPTION

This circuit provides power to operate the clearance warning ECU assembly.

WIRING DIAGRAM

A01W1TXE08
*1 from IG1 NO. 2 Relay
*2 ECU-IG1 NO. 2
*3 Clearance Warning ECU Assembly

CAUTION / NOTICE / HINT

Note

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY POWER SOURCE)


    1. Disconnect the H61 clearance warning ECU assembly connector.

    2. Measure the voltage according to the value(s) is the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      H61-12 (IG) - Body ground Engine switch on (IG) 11 to 14 V
      H61-12 (IG) - Body ground Engine switch off Below 1 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  2. CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - BODY GROUND)


    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      H61-27 (E) - Body ground Always Below 1 Ω

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR