AUDIO AND VISUAL SYSTEM Sound Signal Circuit between Radio Receiver and Stereo Component Amplifier

DESCRIPTION

The radio receiver assembly sends a sound signal to the stereo component amplifier assembly via this circuit.

The sound signal that has been sent is amplified by the stereo component amplifier assembly, and then is sent to the speakers.

If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly or speakers.

WIRING DIAGRAM

A01VZUIE27
*a (Shielded)
*b Radio Receiver Assembly
*c Stereo Component Amplifier Assembly

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY)


    1. Disconnect the H182 radio receiver assembly connector.

    2. Disconnect the H87 stereo component amplifier assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      H182-1 (FR+) - H87-5 (R+) Always Below 1 Ω
      H182-5 (FR-) - H87-4 (R-) Always Below 1 Ω
      H182-2 (FL+) - H87-3 (L+) Always Below 1 Ω
      H182-6 (FL-) - H87-2 (L-) Always Below 1 Ω
      H87-6 (SLD) - Body ground Always 10 kΩ or higher
      H182-1 (FR+) - Body ground Always 10 kΩ or higher
      H182-5 (FR-) - Body ground Always 10 kΩ or higher
      H182-2 (FL+) - Body ground Always 10 kΩ or higher
      H182-6 (FL-) - Body ground Always 10 kΩ or higher

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR