POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM IG Power Source Circuit

DESCRIPTION

When the engine switch is turned on (IG), the IG power source circuit supplies positive (+) voltage to the multiplex tilt and telescopic ECU.

The multiplex tilt and telescopic ECU also receives engine switch signals via this circuit.

WIRING DIAGRAM

A01W1ZNE40
*a from IG Circuit
*b ECU-IG1 NO. 1
*c Multiplex Tilt and Telescopic ECU

CAUTION / NOTICE / HINT

Tech Tips

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - BATTERY)


    1. A01W3C6E02
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Multiplex Tilt and Telescopic ECU)

      Disconnect the H12 multiplex tilt and telescopic ECU connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      H12-10 (IG) - Body ground Engine switch on (IG) 11 to 14 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  2. CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - BODY GROUND)


    1. A01W272E05
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Multiplex Tilt and Telescopic ECU)

      Disconnect the H12 multiplex tilt and telescopic ECU connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      H12-1 (GND) - Body ground Always Below 1 Ω
      H12-8 (GND2) - Body ground Always Below 1 Ω

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR