STEERING ANGLE SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Note

A lock pin is installed to a new steering sensor. Do not remove the lock pin before the steering sensor is installed to the spiral cable sub-assembly.

PROCEDURE


  1. INSPECT SPIRAL CABLE SUB-ASSEMBLY

    Click here

  2. INSTALL STEERING SENSOR


    1. A01VZ8JE05
      Text in Illustration
      *1 Lock Pin
      *a Guide
      *b Pin

      Align the 2 pins and 2 guides, and engage the 6 claws to install the steering sensor to the spiral cable sub-assembly.

      Note


      • Do not remove the lock pin before the steering sensor is installed to the spiral cable sub-assembly.

      • Do not damage the pins of the spiral cable sub-assembly and guides of the steering sensor.

      • The spiral cable sub-assembly can be rotate up to 30° even when the interlock is engaged. Therefore, make sure that both guides are aligned properly when installing the steering sensor to the spiral cable sub-assembly.

    2. B001NVW

      Remove the lock pin from the steering sensor.

  3. ALIGN FRONT WHEELS TO FACE STRAIGHT AHEAD

  4. INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

    Click here