TIRE PRESSURE WARNING RECEIVER INSTALLATION

PROCEDURE


  1. INSTALL TIRE PRESSURE WARNING ECU AND RECEIVER


    1. Connect the connector to the tire pressure warning ECU and receiver.

    2. Engage the 2 tabs into the holes to temporarily install the tire pressure warning ECU and receiver.

    3. A01W4RWE04
      Text in Illustration
      *1 Wire Harness
      *2 Bracket of the Tire Pressure Warning ECU and Receiver

      Install the 2 bolts.

      Torque:
      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

      Note

      Make sure that the wire harness is positioned in front of the bracket of the tire pressure warning ECU and receiver as shown in the illustration.

  2. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY

    Click here

  3. REGISTER TRANSMITTER ID

    Click here

  4. INSPECT TIRE PRESSURE WARNING SYSTEM

    Click here

  5. PERFORM INITIALIZATION

    Click here