PARK / NEUTRAL POSITION SWITCH INSTALLATION

PROCEDURE


  1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    1. Temporarily install the park/neutral position switch assembly to the transaxle case sub-assembly with the 2 bolts.

      Note

      Before installing the park/neutral position switch assembly, remove any dirt or rust on the manual valve lever shaft sub-assembly. Be sure to install the park/neutral position switch assembly straight along the manual valve lever shaft sub-assembly while being careful not to deform the plate spring that supports the manual valve lever shaft sub-assembly. If the plate spring is deformed, the park/neutral position switch assembly cannot be installed correctly.

    2. B001O9NE10
      Text in Illustration
      *a Protrusion

      Align the protrusions of the park/neutral position switch assembly as shown in the illustration.

    3. Hold the park/neutral position switch assembly in position and tighten the 2 bolts.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

      Note

      After installing the park/neutral position switch assembly, confirm that the 2 protrusions on the park/neutral position switch assembly are aligned.

    4. Connect the park/neutral position switch assembly connector.

  2. INSTALL TRANSMISSION CONTROL SHAFT LEVER


    1. Install the transmission control shaft lever to the manual valve lever shaft sub-assembly with the washer and nut.

      Torque:
      13 N*m  { 130 kgf*cm, 9 ft.*lbf }

  3. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Move the shift lever to N.

    2. Connect the transmission control cable assembly to the transmission control shaft lever with the nut.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

    3. Install the transmission control cable assembly to the No. 1 transmission control cable bracket with a new clip.

  4. CONNECT ENGINE WIRE


    1. Engage the clamp to connect the engine wire to the automatic transaxle assembly.

    2. Install the nut to the wire harness clamp bracket.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

  5. INSTALL AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  6. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

    Click here

  7. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE

    Click here

  8. INSTALL INLET AIR CLEANER ASSEMBLY

    Click here

  9. INSTALL COOL AIR INTAKE DUCT SEAL

    Click here

  10. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY OPERATION

    Click here

  11. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

    Click here

  12. INSPECT SHIFT LEVER POSITION

    Click here

  13. ADJUST SHIFT LEVER POSITION

    Click here