OIL PUMP REASSEMBLY

PROCEDURE


  1. INSTALL FRONT OIL PUMP OIL SEAL


    1. A01W1XAE01

      Coat the lip of a new front oil pump oil seal with a small amount of MP grease.

    2. Using SST and a hammer, install the front oil pump oil seal to the front oil pump body sub-assembly.

      SST
      09350-32014   ( 09351-32140 )

      Note

      The seal end should be level with the outer edge of the front oil pump body sub-assembly.

  2. INSTALL FRONT OIL PUMP BODY O-RING


    1. B001OF3

      Coat a new front oil pump body O-ring with ATF and install it to the front oil pump body sub-assembly.

      Note

      Ensure that the O-ring is not twisted.

  3. INSTALL FRONT OIL PUMP DRIVEN GEAR


    1. A01W4G6

      Coat the front oil pump driven gear with ATF and install it to the front oil pump body sub-assembly with the marked side up.

  4. INSTALL FRONT OIL PUMP DRIVE GEAR


    1. A01W49S

      Coat the front oil pump drive gear with ATF, and install it to the front oil pump body sub-assembly with the marked side up.

  5. INSTALL STATOR SHAFT ASSEMBLY


    1. A01W00VE01

      Align each knock pin of the stator shaft assembly with the holes in the front oil pump body sub-assembly and install the stator shaft assembly to the front oil pump body sub-assembly with the 16 "TORX" bolts.

      Bolt Length
      Bolt Length [mm (in.)]
      A 14 (0.551)
      B 26 (1.02)

    2. Using a T30 "TORX" socket wrench, tighten the 16 "TORX" bolts.

      Torque:
      9.3 N*m  { 95 kgf*cm, 82 in.*lbf }

  6. INSPECT FRONT OIL PUMP ASSEMBLY

    Click here