AUTOMATIC TRANSAXLE ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

Note

If automatic transaxle parts are replaced, refer to Parts Replacement Compensation Table to determine if any additional operations are necessary Click here.

PROCEDURE


  1. REMOVE FLYWHEEL HOUSING UNDER COVER

    Click here

  2. REMOVE DRIVE PLATE AND TORQUE CONVERTER ASSEMBLY SETTING BOLT


    1. A01W1NX

      Turn the crankshaft to gain access to the removal locations of the 6 drive plate and torque converter assembly setting bolts and remove each bolt while holding the crankshaft pulley bolt with a wrench.

  3. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE

    Click here

  4. REMOVE FRONT FRAME ASSEMBLY

    Click here

  5. REMOVE WIRING HARNESS CONNECTOR


    1. A01W29N

      Disconnect the wire harness clamp from the wiring harness connector.

    2. Turn the lock lever and disconnect the connector from the wiring harness connector.

    3. A01W0DA

      Remove the 2 bolts and wiring harness connector from the automatic transaxle assembly.

  6. SEPARATE WIRE HARNESS


    1. A01W16D

      Remove the bolt and ground cable.

    2. Separate the park/neutral position switch assembly connector and 7 wire harness clamps.

  7. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY


    1. Using the transmission jack attachment, set the automatic transaxle assembly on a transmission jack.

      Note


      • Secure the automatic transaxle assembly to the transmission jack using a suitable adapter, such as a rope or attachment.

      • To prevent the oil pan from deforming, do not place any attachments onto the oil pan of the automatic transaxle assembly.

      • Hold the engine assembly with a suitable adapter, such as a rope, during the operation.

    2. A01W3V8

      Remove the 9 bolts and automatic transaxle assembly.

      Note

      To prevent damage to the knock pins, do not pry between the automatic transaxle assembly and engine.

  8. REMOVE TRANSMISSION OIL COOLER


    1. A01W0SEE01
      Text in Illustration
      *1 No. 1 Oil Cooler Inlet Hose
      *2 No. 1 Oil Cooler Outlet Hose

      Release the 4 clamps and remove the No. 1 oil cooler inlet hose and No. 1 oil cooler outlet hose from the transmission oil cooler and automatic transaxle assembly.

    2. A01W30D

      Remove the 3 bolts and transmission oil cooler from the front engine mounting bracket.

  9. REMOVE FRONT ENGINE MOUNTING BRACKET


    1. A01W3HT

      Remove the 3 bolts and front engine mounting bracket from the automatic transaxle assembly.

  10. REMOVE NO. 1 TRANSMISSION CONTROL CABLE BRACKET


    1. A01VZ6G

      Remove the 2 bolts and No. 1 transmission control cable bracket from the automatic transaxle assembly.

  11. REMOVE WIRE HARNESS CLAMP BRACKET


    1. A01W5NJ

      Remove the 4 bolts and 4 wire harness clamp brackets from the automatic transaxle assembly.

  12. REMOVE TRANSMISSION CASE PLUG ASSEMBLY


    1. A01W1GE

      Remove the transmission case plug assembly from the transaxle housing.

    2. Remove the O-ring from the transmission case plug assembly.

  13. REMOVE TORQUE CONVERTER ASSEMBLY


    1. A01W235

      Remove the torque converter assembly from the automatic transaxle assembly.