TRANSMISSION CONTROL CABLE INSTALLATION

PROCEDURE


  1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

    Note

    Before installing the transmission control cable assembly, check that the park/neutral position switch assembly and shift lever are in neutral.


    1. Pass the transmission control cable assembly from the cabin to the engine compartment.

    2. Install the transmission control cable assembly to the body with the 2 bolts.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

    3. Install the dash panel insulator to the original position.

    4. Connect the transmission control cable assembly to the No. 1 transmission control cable bracket with a new clip.

    5. Connect the transmission control cable assembly to the transmission control shaft lever with the nut.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

      Note

      Before connecting the transmission control cable assembly, check that the park/neutral position switch assembly and shift lever are in neutral.

    6. Connect the wire harness clamp to the wire harness clamp bracket.

    7. A01W24SE12
      Text in Illustration
      *a Slider
      *b Lock Piece
      *c Slide
      *d Pull

      Slide the slider of the transmission control cable assembly in the direction indicated by the arrow and pull the lock piece outward.

    8. Engage the 2 claws to connect the transmission control cable assembly to the lower shift lever assembly.

    9. A01W1G4E01
      Text in Illustration
      *a Lock Piece

      Connect the transmission control cable assembly to the lower shift lever assembly.

      Note


      • Check that the lock piece is pulled up.

      • Connect the transmission control cable assembly all the way to the base of the pin.

    10. Push the lock piece into the adjuster case.

      Note


      • Check that the park/neutral position switch assembly and shift lever are in neutral.

      • Securely push in the lock piece until the slider lock is engaged.

  2. CONNECT NO. 1 PARKING BRAKE CABLE ASSEMBLY


    1. Install the No. 1 parking brake cable assembly to the body with the bolt and nut.

      Torque:
      Bolt
      15 N*m  { 153 kgf*cm, 11 ft.*lbf }
      Nut
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

    2. Return the floor carpet to its original position.

  3. INSTALL ACCELERATOR PEDAL SENSOR ASSEMBLY

    Click here

  4. INSTALL AIRBAG SENSOR ASSEMBLY

    Click here

  5. INSTALL AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  6. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  7. INSTALL AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  8. INSTALL INLET AIR CLEANER ASSEMBLY

    Click here

  9. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

    Click here

  10. INSTALL COOL AIR INTAKE DUCT SEAL

    Click here

  11. INSPECT SHIFT LEVER POSITION

    Click here