PARK / NEUTRAL POSITION SWITCH REMOVAL

PROCEDURE


  1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

    Click here

  2. REMOVE COOL AIR INTAKE DUCT SEAL

    Click here

  3. REMOVE INLET AIR CLEANER ASSEMBLY

    Click here

  4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  5. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  6. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  7. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    1. A01W0AZ

      Disconnect the wire harness clamp from the wire harness clamp bracket.

    2. B001NYG

      Remove the clip from the transmission cable bracket.

    3. B001O2K

      Remove the nut and transmission control cable assembly from the transmission control shaft lever.

    4. Disconnect the connector from the park/neutral position switch assembly.

    5. B001OEQ

      Remove the nut, washer and transmission control shaft lever from the manual valve lever shaft sub-assembly.

    6. A01W58D

      Remove the 2 bolts and park/neutral position switch assembly from the manual valve lever shaft sub-assembly.

      Note

      Before removing the park/neutral position switch assembly, remove any foreign matter or rust on the installation portion of the manual valve lever shaft sub-assembly. Be sure to remove the switch straight along the shaft while being careful not to deform the plate spring that supports the shaft. If the plate spring is deformed, the park/neutral position switch assembly cannot be reinstalled correctly.