PARK / NEUTRAL POSITION SWITCH REMOVAL

PROCEDURE


  1. REMOVE COOL AIR INTAKE DUCT SEAL

    Click here

  2. REMOVE INLET NO. 2 AIR CLEANER

    Click here

  3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  4. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  5. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  6. SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Move the shift lever to N.

    2. A01W0X4

      Disconnect the wire harness clamp.

    3. A01W534

      Remove the clip and nut, and disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket and control shaft lever.

  7. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    1. Disconnect the connector from the park/neutral position switch assembly.

    2. B001OEQ

      Remove the nut, washer and control shaft lever from the manual valve lever shaft.

    3. A01W4GU

      Remove the 2 bolts and park/neutral position switch assembly from the manual valve lever shaft.

      Note

      Before removing the park/neutral position switch assembly, remove any foreign matter or rust on the installation portion of the manual valve lever shaft. Be sure to remove the switch straight along the shaft while being careful not to deform the plate spring that supports the shaft. If the plate spring is deformed, the park/neutral position switch assembly cannot be reinstalled correctly.