TRANSMISSION CONTROL CABLE ADJUSTMENT

PROCEDURE


  1. INSPECT SHIFT LEVER POSITION


    1. When the shift lever is moved from P to R with the engine switch on (IG) and brake pedal depressed, make sure that the shift lever moves smoothly and correctly into position.

    2. Start the engine and make sure that the vehicle moves forward when the shift lever is moved from N to D and moves rearward when the shift lever is moved to R.

  2. ADJUST SHIFT LEVER POSITION


    1. Move the shift lever to N.

    2. Remove the rear console box assembly Click here.

    3. A01W4GG

      Disconnect the transmission control cable assembly from the lower shift lever assembly.

    4. Disengage the 2 claws to disconnect the transmission control cable assembly from the lower shift lever assembly.

    5. A01W24SE12
      Text in Illustration
      *a Slider
      *b Lock Piece
      *c Slide
      *d Pull

      Slide the slider of the transmission control cable assembly in the direction indicated by the arrow and pull the lock piece outward.

    6. Engage the 2 claws to connect the transmission control cable assembly to the lower shift lever assembly.

    7. A01W1G4E01
      Text in Illustration
      *a Lock Piece

      Connect the transmission control cable assembly to the lower shift lever assembly.

      Note


      • Check that the lock piece is pulled up.

      • Connect the transmission control cable assembly all the way to the base of the pin.

    8. Push the lock piece into the adjuster case.

      Note


      • Check that the park/neutral position switch assembly and shift lever are in neutral.

      • Securely push in the lock piece until the slider lock is engaged.

    9. After adjusting the shift lever position, check the operation and function of the shift lever. If there is a problem, adjust the position again.

    10. Install the rear console box assembly Click here.