MILLIMETER WAVE RADAR SENSOR INSTALLATION

PROCEDURE

1. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY

   Note

   If the front bumper assembly or radiator grill has been replaced, check that the beam axis change mechanism is at the standard position (centered).

   
   

   1. Set beam axis to the standard position.

      
      

      1. 

         Turn the bolt so that the beam axis change mechanism is positioned as shown in the illustration.

         Specified Condition
         Difference between (A) and (B): 1 mm (0.0394 in.) or less

   2. Engage the 2 guides.

   3. 

      Tighten the 2 bolts and 2 screws on the millimeter wave radar sensor assembly.

      Torque:

      Bolt

      2.5 N*m  { 25 kgf*cm, 22 in.*lbf }

      Tech Tips

      Tighten the bolts in the order shown in the illustration.

   4. Connect the connector.

2. INSTALL COOL AIR INTAKE DUCT SEAL

   Click here

3. ADJUST MILLIMETER WAVE RADAR SENSOR

   
   

   1. When the millimeter wave radar sensor assembly or No. 1 millimeter wave radar sensor bracket is replaced with a new one, adjustment of the radar sensor beam axis must be performed. Click here