DYNAMIC RADAR CRUISE CONTROL SYSTEM(for 6AR-FSE) ECU Power Source Circuit

DESCRIPTION

This circuit provides power to operate the driving support ECU assembly. The driving support ECU assembly determines information about the vehicle in front based on data from the radar sensor, and then decides how much acceleration and/or deceleration is needed to maintain the set distance. The driving support ECU assembly also requests the skid control ECU to apply brakes and sounds the skid control buzzer assembly.

WIRING DIAGRAM

A01W5F8E03
*1 from Engine Stop and Start ECU Assembly
*2 Driving Support ECU Assembly

PROCEDURE


  1. CHECK DRIVING SUPPORT ECU ASSEMBLY (B VOLTAGE)


    1. A01W130E02
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Driving Support ECU Assembly)

      Disconnect the H194 driving support ECU assembly connector.

    2. Turn the engine switch on (IG).

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      H194-7 (B) - Body ground Engine switch on (IG) 11 to 14 V

    4. Turn the engine switch off.

    5. Reconnect the H194 driving support ECU assembly connector.


    NG

    REPAIR OR REPLACE POWER SOURCE CIRCUIT

    OK

  2. CHECK HARNESS AND CONNECTOR (DRIVING SUPPORT ECU ASSEMBLY - BODY GROUND)


    1. Disconnect the H194 driving support ECU assembly connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance (Check for Open)
      Tester Connection Condition Specified Condition
      H194-28 (GND) - Body ground Always Below 1 Ω

    3. Reconnect the H194 driving support ECU assembly connector.


    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR