REAR CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL ENGINE REAR OIL SEAL


    1. A01W3XRE03
      Text in Illustration
      *1 Retainer
      *a

      Oil seal tap in depth

      (-0.5 to 0.5 mm)

      Apply MP grease to a new engine rear oil seal lip.

    2. Using SST and a hammer, tap in the engine rear oil seal.

      SST
      09223-15030
      09950-70010   ( 09951-07150 )
      Oil seal tap in depth
      -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)

  2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    1. Using SST, hold the crankshaft pulley.

      SST
      09213-70011   ( 09213-70020 )
      09330-00021

    2. Clean the 8 bolts and 8 bolt holes.

    3. A01W1FN

      Install the front drive plate spacer.

      Tech Tips

      Align the pin of the front drive plate spacer with the pin hole of the crankshaft.

    4. A01W0SBE05
      Text in Illustration
      *1 Drive Plate
      *2 Rear Spacer
      B001O8N Transaxle Side

      Install the drive plate and ring gear sub-assembly and rear drive plate spacer onto the crankshaft.

    5. A01W2BVE37
      Text in Illustration
      *1 Adhesive

      Apply a few drops of adhesive to 2 or 3 threads at the tip of each of the 8 bolts.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
    6. A01W0H4E05

      Install and uniformly tighten the 8 bolts in several steps in the sequence shown in the illustration.

      Torque:
      83 N*m  { 846 kgf*cm, 61 ft.*lbf }

      Note

      Do not start the engine for at least an hour after installing the drive plate and ring gear sub-assembly.

  3. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY

    Click here