REAR CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL REAR ENGINE OIL SEAL


    1. Using a height adjustable attachment and plate lift attachment, place the engine assembly on a flat level surface.

      Note


      • Using a height adjustable attachment and plate lift attachment, place the engine assembly horizontally.

      • To prevent the oil pan sub-assembly from deforming, do not place any attachments onto the oil pan sub-assembly of the engine assembly.

      • Using an engine sling device and engine lift, secure the engine assembly before service.

    2. Apply MP grease to the lip of a new rear engine oil seal.

      Note


      • Do not allow foreign matter to contact the lip of the rear engine oil seal.

      • Do not allow MP grease to contact the dust seal.

    3. A01W3VBE06

      Using SST and a hammer, tap in the rear engine oil seal until its surface is flush with the edges of the cylinder block sub-assembly and stiffening crankcase assembly.

      SST
      09223-15030
      09950-70010   ( 09951-07150 )

      Note


      • Keep the lip of the rear engine oil seal free from foreign matter.

      • Do not tap in the rear engine oil seal at an angle.

  2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    1. A01W57NE07

      Using SST, hold the crankshaft.

      SST
      09213-54015
      09330-00021

      Tech Tips

      SST (Crankshaft pulley holding tool) Fixing bolt part No. : 91551-80650(2 pcs)

    2. Clean the bolts and their installation holes.

    3. A01W4O0

      Install the front drive plate spacer.

      Tech Tips

      Align the pin of the front drive plate spacer with the pin hole of the crankshaft.

    4. A01VZGCE05
      Text in Illustration
      *1 Drive Plate and Ring Gear Sub-assembly
      *2 Rear Drive Plate Spacer
      B001O8N Transaxle Side

      Install the drive plate and ring gear sub-assembly and rear drive plate spacer onto the crankshaft.

    5. A01W23LE03
      Text in Illustration
      *1 Adhesive

      Apply a few drops of adhesive to 2 or 3 threads at the tip of each of the 8 bolts.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
    6. A01VZ7TE02

      Install and uniformly tighten the 8 bolts in several steps in the sequence shown in the illustration.

      Torque:
      98 N*m  { 999 kgf*cm, 72 ft.*lbf }

      Note

      Do not start the engine for at least an hour after installing the drive plate and ring gear sub-assembly.

  3. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY

    Click here