REAR CRANKSHAFT OIL SEAL REMOVAL

PROCEDURE


  1. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY

    Click here

  2. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    1. Using a height adjustable attachment and plate lift attachment, place the engine assembly on a flat level surface.

      Note


      • Using a height adjustable attachment and plate lift attachment, place the engine assembly horizontally.

      • To prevent the oil pan sub-assembly from deforming, do not place any attachments onto the oil pan sub-assembly of the engine assembly.

      • Using an engine sling device and engine lift, secure the engine assembly before service.

    2. A01W57NE07

      Using SST, hold the crankshaft pulley.

      SST
      09213-54015
      09330-00021

      Tech Tips

      SST (Crankshaft pulley holding tool) Fixing bolt part No. : 91551-80650(2 pcs)

    3. A01W2W0

      Remove the 8 bolts, front drive plate spacer, drive plate and ring gear sub-assembly, and rear drive plate spacer.

  3. REMOVE REAR ENGINE OIL SEAL


    1. A01W34QE02
      Text in Illustration
      *1 Protective Tape
      *a Cut Position

      Using a knife, cut off the lip of the rear engine oil seal.

    2. Using a screwdriver, pry out the rear engine oil seal.

      Note

      Do not damage the surface of the rear engine oil seal press fit hole or the crankshaft.

      Tech Tips

      Tape the screwdriver tip before use.