FRONT CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL TIMING CHAIN COVER OIL SEAL


    1. Apply MP grease to the lip of a new timing chain cover oil seal.

      Note


      • Do not allow foreign matter to contact the lip of the timing chain cover oil seal.

      • Do not allow MP grease to contact the dust seal.

    2. A01W12PE06

      Using SST and a hammer, tap in the timing chain cover oil seal until its surface is flush with the timing chain cover edge.

      SST
      09223-22010

      Note


      • Keep the lip of the timing chain cover oil seal free from foreign matter.

      • Do not tap in the timing chain cover oil seal at an angle.

  2. INSTALL CRANKSHAFT PULLEY


    1. Align the crankshaft pulley key with the key groove of the crankshaft pulley.

    2. A01W0VFE03
      Text in Illustration
      *1 Washer
      *a Hold
      *b Turn

      Using SST, hold the crankshaft pulley and install the pulley bolt.

      SST
      09213-54015   ( 09214-00030 )
      09213-70011
      09330-00021
      Torque:
      260 N*m  { 2651 kgf*cm, 192 ft.*lbf }

      Tech Tips

      Insert a few washers (thickness: approximately 5 mm (0.197 in.)) between SST(09213-70011) and SST(09214-00030).

  3. INSTALL V-RIBBED BELT

    Click here

  4. INSTALL FRONT FENDER APRON SEAL RH

  5. INSTALL ENGINE UNDER COVER RH

  6. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH

  7. INSTALL FRONT WHEEL RH

    Torque:
    103 N*m  { 1049 kgf*cm, 76 ft.*lbf }