THROTTLE BODY REMOVAL

PROCEDURE


  1. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH

  2. REMOVE ENGINE UNDER COVER RH

  3. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH

  4. REMOVE ENGINE UNDER COVER LH

  5. DRAIN ENGINE COOLANT

    Click here

  6. REMOVE V-BANK COVER SUB-ASSEMBLY

    Click here

  7. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    1. A01W1WD

      Disconnect the mass air flow meter connector and wire harness clamp.

    2. A01W5IR

      Disconnect the 3 hoses.

    3. Disconnect the ventilation hose from the air cleaner cap sub-assembly.

    4. A01W3VM

      Loosen the hose clamp and separate the air cleaner cap sub-assembly from the throttle with motor body assembly.

    5. Release the 2 clamps and remove the air cleaner cap sub-assembly.

  8. REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY


    1. A01W5P9

      Disconnect the 2 water by-pass hoses from the throttle with motor body assembly.

    2. A01VZHS

      Disconnect the throttle with motor body assembly connector and wire harness clamp.

    3. Remove the 4 bolts, throttle with motor body assembly and wire harness clamp stay.

    4. Remove the gasket from the intake air surge tank assembly.