ACCELERATOR PEDAL ON-VEHICLE INSPECTION

PROCEDURE

1. CHECK ACCELERATOR PEDAL SENSOR ASSEMBLY

   
   

   1. Measure the voltage.

      
      

      1. Connect the GTS to the DLC3.

      2. Turn the engine switch on (IG).

      3. Turn the GTS on.

      4. Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Accel Sensor Out No. 1 and Accel Sensor Out No. 2.

      5. Read the values displayed on the GTS.

         Standard Voltage
         Accelerator Pedal Operation Accel Sensor Out No. 1 Accel Sensor Out No. 2 Fully Released 0.5 to 1.1 V 1.2 to 2.0 V Fully Depressed 2.6 to 4.5 V 3.4 to 4.98 V

         If the results are not as specified, check the accelerator pedal sensor assembly, wire harness or ECM.