ECM REMOVAL

CAUTION / NOTICE / HINT

Note


  • Perform the Vehicle Identification Number (VIN) registration when replacing the ECM Click here.

  • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.

PROCEDURE


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  2. REMOVE BATTERY

    Click here

  3. REMOVE ECM


    1. A01VZBJ

      Remove the bolt.

    2. Disengage the 2 wire harness clamps.

    3. A01VZEJ

      Raise the 2 levers while pushing the locks on the levers, and disconnect the 2 ECM connectors.

      Note

      After disconnecting the ECM connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the ECM connectors.

    4. Disengage the wire harness clamp.

    5. A01W08F

      Remove the 3 nuts and ECM.

      Note

      If the ECM has been struck or dropped, replace it.

  4. REMOVE NO. 1 ECM BRACKET


    1. A01W29A

      Remove the 2 screws and No. 1 ECM bracket from the ECM.

  5. REMOVE NO. 2 ECM BRACKET


    1. A01VZ53

      Remove the 2 screws and No. 2 ECM bracket from the ECM.