THROTTLE BODY REMOVAL

PROCEDURE


  1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

    Click here

  2. DRAIN ENGINE COOLANT

    Click here

  3. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE


    1. A01VZZ0

      Slide the clip and disconnect the ventilation hose from the cylinder head cover sub-assembly.

    2. Disengage the ventilation hose clamp.

    3. A01W2LJ

      Disconnect the mass air flow meter sub-assembly connector.

    4. Disengage the wire harness clamp.

    5. A01W1Q7

      Disconnect the union to check valve hose from the air cleaner hose sub-assembly.

    6. Disengage the 2 air cleaner cap clamps and 2 guides.

    7. A01W31W

      Loosen the hose clamp and remove the air cleaner cap with air cleaner hose from the throttle body with motor assembly.

  4. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY


    1. A01W3CE

      Disconnect the throttle body with motor assembly connector.

    2. Remove the 4 bolts and throttle body with motor assembly from the intake manifold.

      Note

      If the throttle body with motor assembly has been struck or dropped, replace it.

    3. A01W3C3E02
      Text in Illustration
      *1 No. 2 Water By-pass Hose
      *2 No. 3 Water By-pass Hose

      Slide the 2 clips and disconnect the No. 2 water by-pass hose and No. 3 water by-pass hose from the throttle body with motor assembly.

  5. REMOVE THROTTLE BODY GASKET


    1. A01W24J

      Remove the throttle body gasket from the intake manifold.