THROTTLE BODY INSTALLATION

PROCEDURE


  1. INSTALL THROTTLE WITH MOTOR BODY ASSEMBLY


    1. Install a new gasket to the intake manifold.

    2. Install the fuel tube bracket with the bolt.

      Torque:
      13 N*m  { 133 kgf*cm, 10 ft.*lbf }

    3. Install the throttle with motor body assembly with the 4 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

    4. Connect the throttle body connector.

    5. Connect the fuel tube to the fuel tube bracket.

    6. Connect the No. 2 water by-pass hose to the throttle with motor body assembly.

    7. Connect the No. 1 water by-pass hose to the throttle with motor body assembly.

  2. INSTALL AIR CLEANER CAP SUB-ASSEMBLY


    1. A01W2STE02
      Text in Illustration
      *a Hinge
      *b Clamp

      Connect the 2 hinges of the air cleaner cap sub-assembly.

    2. Install the air cleaner cap sub-assembly with the 2 clamps.

    3. Connect the air cleaner cap sub-assembly to the throttle with motor body assembly the hose clamp.

    4. Connect the ventilation hose to the cylinder head cover.

    5. Install the fuel vapor feed hose to the air cleaner hose.

    6. Connect the mass air flow meter connector and 2 wire harness clamps to the air cleaner cap sub-assembly.

    7. Connect the vacuum switching valve assembly to the air cleaner cap sub-assembly.

  3. ADD ENGINE COOLANT

    Click here

  4. INSPECT FOR COOLANT LEAK

    Click here

  5. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

    Click here

  6. PERFORM INITIALIZATION

    Note


    • Be sure to perform this procedure after removing and reinstalling the throttle with motor body assembly or any throttle with motor body assembly components.

    • Perform the following procedure after replacing the throttle with motor body assembly or any throttle with motor body assembly components. The following procedure should also be performed if the throttle with motor body assembly is cleaned.


    1. Turn the engine switch on (IG) without operating the accelerator pedal.

      Note

      If the accelerator pedal is operated, perform the above step again.

    2. Connect the GTS to the DLC3 and clear the DTCs Click here.

    3. Perform "Inspection After Repair" Click here.

    4. Start the engine and check that the MIL is not illuminated. After the engine is warmed up, check that the idle speed is within the specified range with the A/C switch off.

      Standard
      Condition Engine Idle Speed
      A/C switch off 610 to 710 rpm

      Note


      • Be sure to perform this step with all accessories off.

      • Make sure that the shift lever is in N.

    5. Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Throttle Sensor Position. Fully depress the accelerator pedal and check that the value is 60% or more.

    6. Perform a road test and confirm that there are no abnormalities.