STOP LIGHT SWITCH INSTALLATION

PROCEDURE

INSTALL STOP LIGHT SWITCH ASSEMBLY

Insert the stop light switch assembly until the threaded sleeve hits the pedal.

Note

When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.
Turn the stop light switch assembly 1/4 clockwise to install it.

Torque:

1.5 N*m { 15 kgf*cm, 13 in.*lbf }

or less

Note

When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.
Connect the connector.

Check the protrusion of the plunger.

Protrusion of the plunger
Area	Measurement
a	0.6 to 2.6 mm (0.0236 to 0.102 in.)

for LHD
If the protrusion is not as specified, recheck switch installation and inspect brake pedal adjustment if necessary (See page Click here).

for RHD
If the protrusion is not as specified, recheck switch installation and inspect brake pedal adjustment if necessary (See page Click here).

Note

Do not depress or support the brake pedal.