WIPER SWITCH ON-VEHICLE INSPECTION

PROCEDURE


  1. INSPECT FRONT WIPER INTERMITTENT OPERATION (w/o Auto Wiper System)


    1. Check the front wiper intermittent operation (for LHD).


      1. A01W4CJE02
        Text in Illustration
        *a

        Component with harness connected

        (Windshield Wiper Switch Assembly)

        Connect a voltmeter positive (+) lead to terminal H25-3 (+1) and a negative (-) lead to terminal H24-4 (EW).

      2. Turn the engine switch on (IG).

      3. Turn the wiper switch to the INT position.

      4. Operate the intermittent wiper and check the voltage between terminals H25-3 (+1) and H24-4 (EW).

        OK
        Voltage changes as shown in the illustration.
        A01VZS2E18

        If the result is not as specified, replace the windshield wiper switch assembly.

    2. Check the front wiper intermittent operation (for RHD).


      1. A01W0EOE01
        Text in Illustration
        *a

        Component with harness connected

        (Windshield Wiper Switch Assembly)

        Connect a voltmeter positive (+) lead to terminal H25-2 (+1) and a negative (-) lead to terminal H24-7 (EW).

      2. Turn the engine switch on (IG).

      3. Turn the wiper switch to the INT position.

      4. Operate the intermittent wiper and check the voltage between terminals H25-2 (+1) and H24-7 (EW).

        OK
        Voltage changes as shown in the illustration.
        A01VZS2E89

        If the result is not as specified, replace the windshield wiper switch assembly.

  2. INSPECT FRONT WASHER OPERATION


    1. Check the front washer operation (for LHD).


      1. A01W4CJE02
        Text in Illustration
        *a

        Component with harness connected

        (Windshield Wiper Switch Assembly)

        Connect a voltmeter positive (+) lead to terminal H25-3 (+1) and a negative (-) lead to terminal H24-4 (EW).

      2. Turn the engine switch on (IG).

      3. Turn the washer switch on and off, and check the voltage between terminals H25-3 (+1) and H24-4 (EW).

        OK
        Voltage changes as shown in the following illustration.
        A01W35GE97

        If the result is not as specified, replace the windshield wiper switch assembly.

    2. Check the front washer operation (for RHD).


      1. A01W0EOE01
        Text in Illustration
        *a

        Component with harness connected

        (Windshield Wiper Switch Assembly)

        Connect a voltmeter positive (+) lead to terminal H25-2 (+1) and a negative (-) lead to terminal H24-7 (EW).

      2. Turn the engine switch on (IG).

      3. Turn the washer switch on and off, and check the voltage between terminals H25-2 (+1) and H24-7 (EW).

        OK
        Voltage changes as shown in the following illustration.
        A01W35GE98

        If the result is not as specified, replace the windshield wiper switch assembly.