LUGGAGE COMPARTMENT DOOR OPENER INNER SWITCH INSPECTION

PROCEDURE


  1. INSPECT LUGGAGE DOOR OPENING SWITCH ASSEMBLY


    1. A01W4J7E02
      Text in Illustration
      *a

      Component without harness connected

      (Luggage Door Opening Switch Assembly)

      Check the resistance.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        6 (B) - 3 (L) Switch off 10 kΩ or higher
        Switch on Below 1 Ω

        If the result is not as specified, replace the luggage door opening switch assembly.

    2. Inspect the illumination.


      1. Apply battery voltage to the luggage door opening switch assembly connector, and check that the luggage door opening switch assembly LED illuminates.

        OK
        Measurement Condition Specified Condition

        Battery positive (+) → Terminal 5 (ILL+)

        Battery negative (-) → Terminal 4 (ILL-)

        		 LED illuminates

        If the result is not as specified, replace the luggage door opening switch assembly.