HOOD ADJUSTMENT

CAUTION / NOTICE / HINT

A01W00FE01
Text in Illustration
*1 Centering Bolt
*2 Standard Bolt

Tech Tips


  • Centering bolts are used to mount the hood hinge and hood lock. The hood and hood lock cannot be adjusted with the centering bolts installed. Substitute the centering bolts with standard bolts when making adjustments.

  • Specified torque for standard bolts is shown in the standard bolt chart Click here.

PROCEDURE


  1. INSPECT HOOD SUB-ASSEMBLY

    Click here

  2. ADJUST HOOD SUB-ASSEMBLY


    1. Horizontally and vertically adjust the hood.


      1. A01W57R

        Loosen the 4 hinge bolts of the hood.

      2. Adjust the clearance between the hood and front fender by moving the hood.

      3. Tighten the 4 hinge bolts after the adjustment.

        Torque:
        13 N*m  { 133 kgf*cm, 10 ft.*lbf }

    2. Adjust the height of the front end of the hood using the hood bumper cushions.


      1. A01W092

        Adjust the 2 hood bumper cushions so that the heights of the hood and fender are aligned.

        Tech Tips

        Raise or lower the front end of the hood by turning the 2 cushion rubbers.

    3. Remove the cool air intake duct seal Click here.

    4. Adjust the hood lock.


      1. A01W39I

        Loosen the 3 bolts.

      2. Tighten the bolts after adjustment.

        Torque:
        8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

      3. Check that the striker can engage with the hood lock smoothly.

    5. Install the cool air intake duct seal Click here.