COMPRESSOR(for 2GR-FE) DISASSEMBLY

PROCEDURE


  1. REMOVE COOLER BRACKET


    1. A01W1RL

      Disconnect the connector.

    2. Disengage the clamp.

    3. Remove the screw and cooler bracket.

  2. REMOVE MAGNET CLUTCH ASSEMBLY


    1. A01W1V1E03

      Clamp the compressor and magnetic clutch in a vise between aluminum plates.

    2. Using SST, hold the magnet clutch hub.

      SST
      07112-76060

    3. Remove the bolt, magnet clutch hub and magnet clutch washer(s).

      Tech Tips

      There is no set number of magnet clutch washers that are used for adjusting clutch clearance.

    4. A01W2IQ

      Using a snap ring expander, remove the snap ring and magnet clutch rotor.

      Note

      Do not damage the seal cover of the bearing when removing the snap ring.

    5. Disengage the clamp.

    6. A01W006

      Using a snap ring expander, remove the snap ring and magnet clutch stator.