FRONT EVAPORATOR TEMPERATURE SENSOR INSTALLATION

PROCEDURE


  1. INSTALL EVAPORATOR TEMPERATURE SENSOR (NO. 1 COOLER THERMISTOR)


    1. except Cold Storage Evaporator:


      1. A01W4BAE13
        Text in Illustration
        *a Fixed Part
        *b Sensor Part

        Install the evaporator temperature sensor (No. 1 cooler thermistor) as shown in the illustration.

        Part Length
        A 34.3 mm 1.35 in.
        B 20.9 mm 0.823 in.
        C 50.0 mm 1.97 in.

        Note


        • Be sure to insert the evaporator temperature sensor (No. 1 cooler thermistor) only once because reinserting it into the same position will not allow it to be firmly secured.

        • When reusing the No. 1 cooler evaporator sub-assembly, insert the sensor part of the evaporator temperature sensor (No. 1 cooler thermistor) one row from the row that has been used previously (X in the illustration).

        • After inserting the evaporator temperature sensor (No. 1 cooler thermistor), do not apply excessive force to the wire.

        • Directly insert the evaporator temperature sensor (No. 1 cooler thermistor) until the edge of plastic case "a" comes into contact with No. 1 cooler evaporator sub-assembly "b".

    2. for Cold Storage Evaporator:


      1. A01W4WXE02
        Text in Illustration
        *a Fixed Part
        *b Sensor Part

        Install the evaporator temperature sensor (No. 1 cooler thermistor) as shown in the illustration.

        Part Length
        A 67.8 mm 2.67 in.
        B 41.0 mm 1.61 in.
        C 50.0 mm 1.97 in.
        D 40.0 mm 1.57 in.
        E 25.0 mm 0.984 in.

        Note


        • Be sure to insert the evaporator temperature sensor (No. 1 cooler thermistor) only once because reinserting it into the same position will not allow it to be firmly secured.

        • When reusing the No. 1 cooler evaporator sub-assembly, insert the sensor part of the evaporator temperature sensor (No. 1 cooler thermistor) 3 rows from the row that has been used previously (X in the illustration).

        • After inserting the evaporator temperature sensor (No. 1 cooler thermistor), do not apply excessive force to the wire.

        • Directly insert the evaporator temperature sensor (No. 1 cooler thermistor) until the edge of plastic case "a" comes into contact with No. 1 cooler evaporator sub-assembly "b".

  2. INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY

    Click here

  3. INSTALL COOLER EXPANSION VALVE

    Click here

  4. INSTALL HEATER PACKING

    Click here

  5. INSTALL AIR CONDITIONING HARNESS ASSEMBLY

    Click here

  6. INSTALL BLOWER ASSEMBLY

    for LHD: Click here

    for RHD: Click here

  7. INSTALL AIR CONDITIONING UNIT ASSEMBLY

    Click here