POWER SEAT SWITCH(for Front Passenger Side) INSPECTION

PROCEDURE


  1. INSPECT POWER SEAT SWITCH ASSEMBLY


    1. Measure the resistance according to the value(s) in the table below.


      1. A01W1OYE02
        Text in Illustration
        *1 Reclining Switch
        *2 Slide Switch
        *3 Front
        *4 Rear
        *a

        Component without harness connected

        (Power Seat Switch Assembly)

        for LHD

        Standard Resistance
        Reclining Switch
        Tester Connection Condition Specified Condition
        3 - 4 Front Below 1 Ω
        3 - 4 Off 10 kΩ or higher
        3 - 5
        3 - 5 Rear Below 1 Ω
        Slide Switch
        Tester Connection Condition Specified Condition
        2 - 3 Front Below 1 Ω
        2 - 3 Off 10 kΩ or higher
        1 - 3
        1 - 3 Rear Below 1 Ω

        If the result is not as specified, replace the power seat switch assembly.

      2. A01W4IHE02
        Text in Illustration
        *1 Reclining Switch
        *2 Slide Switch
        *3 Front
        *4 Rear
        *a

        Component without harness connected

        (Power Seat Switch Assembly)

        for RHD

        Standard Resistance
        Reclining Switch
        Tester Connection Condition Specified Condition
        2 - 3 Front Below 1 Ω
        2 - 3 Off 10 kΩ or higher
        3 - 1
        3 - 1 Rear Below 1 Ω
        Slide Switch
        Tester Connection Condition Specified Condition
        3 - 4 Front Below 1 Ω
        3 - 4 Off 10 kΩ or higher
        3 - 5
        3 - 5 Rear Below 1 Ω

        If the result is not as specified, replace the power seat switch assembly.