WINDSHIELD OUTSIDE MOULDING REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. REMOVE WINDSHIELD OUTSIDE MOULDING

   
   

   1. 

      Text in Illustration

      *1	Protective Tape

      Put protective tape around the windshield outside moulding.

   2. 

      Disengage the claw.

   3. 

      Using a moulding remover, disengage the 10 claws.

   4. Disengage the guide and remove the windshield outside moulding.

2. REMOVE WINDSHIELD NO. 1 OUTSIDE MOULDING CLIP

   Tech Tips

   Perform the following procedure only when replacement of a windshield No. 1 outside moulding clip is necessary.

   
   

   1. 

      Disengage the 5 claws and remove the 5 windshield No. 1 outside moulding clips as shown in the illustration.

3. REMOVE WINDSHIELD NO. 3 OUTSIDE MOULDING CLIP

   Tech Tips

   Perform the following procedure only when replacement of a windshield No. 3 outside moulding clip is necessary.

   
   

   1. Remove the windshield glass.

      Click here.)

   2. Insert a 4.0 mm (0.157 in.) drill bit into a drill.

   3. 

      Text in Illustration

      *a

      Tape

      Tape the 4.0 mm (0.157 in.) drill bit 5.0 mm (0.197 in.) from the tip as shown in the illustration.

      Area	Dimension
      A	5.0 mm (0.197 in.)

      Note

      Tape the 4.0 mm (0.157 in.) drill bit to prevent the drill bit from going too deep.

   4. 

      Text in Illustration

      *a

      Flange

      Lightly press the drill bit against the No. 3 windshield outside moulding clip to drill off the windshield No. 3 outside moulding clip flanges, and remove the 5 No. 3 windshield outside moulding clips.

      Note

      
      

      • Make sure to protect both the inside and outside of the vehicle as the windshield No. 3 outside moulding clip shavings will fly about.

      • Pressing the drill too firmly will cause the windshield No. 3 outside moulding clip to turn and result in the windshield No. 3 outside moulding clip not being drilled through.

      • Prying the windshield No. 3 outside moulding clips with the drill may damage the windshield No. 3 outside moulding clip installation holes or drill bit.

      • Be careful of the drilled windshield No. 3 outside moulding clips, as they may be hot.

   5. Using a vacuum cleaner, remove the windshield No. 3 outside moulding clip fragments and shavings from the drilled areas.