REAR SUSPENSION CROSSMEMBER TWO-DIMENSIONAL DISTANCE
Tech Tips
-
Length measurements are indicated at the points where the arrows extending from the zero point intersect the lines that extend towards the outside of the illustration from each point.
-
In cases in which only one dimension is given, left and right are symmetrical.
-
For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).
| Symbol | Name | Hole Diameter mm (in.) |
|---|---|---|
| A, a | Rear Suspension Member Installation Hole | φ49.5 (1.95) |
| B, b | Rear Suspension Lower Arm Installation Hole | φ16 (0.63) |
| C, c | Rear Suspension Member Standard Hole | φ15 (0.59) |
| D, d | Rear Suspension Member Installation Hole | φ49.5 (1.95) |
| E, e | Rear Suspension Lower Arm Installation Hole | φ16 (0.63) |
| *1 | Front |
| *2 | mm |
| *3 | (in.) |
| *1 | Imaginary Datum Line |
| *2 | Height from Imaginary Datum Line |
| *3 | mm |
| *4 | (in.) |