OIL PRESSURE SENSOR INSTALLATION

PROCEDURE

1. INSTALL OIL PRESSURE SENSOR

   1. Apply Toyota Genuine CVT fluid FE to the O-ring.

      Note:

      If reusing the oil pressure sensor, check that the O-ring is not damaged.

   2. 

      *a	Torque Wrench Fulcrum Length

      Using SST, install the oil pressure sensor to the continuously variable transaxle assembly.

      09326-22011

      Specified tightening torque

      20.6 N*m

      210 kgf*cm

      15 ft.*lbf

      Tip:

      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using SST (fulcrum length of 50 mm (1.97 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)):

        16.1 N*m (164 kgf*cm, 12 ft.*lbf)

   3. Connect the oil pressure sensor connector.

2. INSPECT FOR FLUID LEAK

3. INSTALL REAR ENGINE UNDER COVER LH (for 1ZR-FE)

   Click here

4. INSTALL REAR ENGINE UNDER COVER LH (for 2ZR-FE)

   Click here

5. INSTALL NO. 1 ENGINE UNDER COVER (for 1ZR-FE)

   Click here

6. INSTALL NO. 1 ENGINE UNDER COVER (for 2ZR-FE)

   Click here

7. INSTALL FRONT WHEEL LH

   Click here

8. RESET MEMORY

   Click here