FUEL LID OPENER UNIT INSTALLATION

PROCEDURE


  1. INSTALL FUEL FILLER OPENING LID SUB-ASSEMBLY


    1. B005SYBC02
      *a Rib

      Install the fuel tank filler pipe shield with the rib facing upward as shown in the illustration.

    2. Install the fuel inlet box ring to the fuel tank filler pipe shield as shown in the illustration.

      B005RINC02
      *1 Fuel Inlet Box Ring - -

      Tech Tips

      Put the cut in the fuel inlet box ring downward.

    3. B005WPYC02
      *a Lip
      B006GBM Protective Tape

      Apply protective tape to the fuel filler opening lid sub-assembly as shown in the illustration.

      Note


      • Apply protective tape with the lip appearing as shown in the illustration (a).

      • Check that lip is not deformed as shown in the illustration (b).

      Tech Tips

      This step is not required when using a new part with tape already applied.

    4. B005WFOC02
      B006DHE Install in this Direction

      Insert the fuel filler opening lid sub-assembly as shown in the illustration.

    5. B005TUYC02
      *a Protective Tape

      Remove the protective tape as shown in the illustration.

      Tech Tips

      Use the same procedure to remove the tape when using a new part with tape already applied.

    6. Install the fuel filler opening lid sub-assembly with the 4 screws.

    7. Install the fuel tank filler pipe shield as shown in the illustration.

      B005VR8N01

    8. Install the fuel inlet box ring to the fuel tank filler pipe shield as shown in the illustration.

      B005QKUC02
      *1 Fuel Inlet Box Ring - -

      Tech Tips

      Put the cut in the fuel inlet box ring downward.

  2. INSTALL FUEL TANK CAP ASSEMBLY


    1. Attach the clamp.

    2. B005V6EC02
      B006DHE Install in this Direction

      Turn the fuel tank cap assembly in the direction of the arrow shown in the illustration to install it.

  3. INSTALL FUEL FILLER OPENING LID ASSEMBLY


    1. B005VG5C02
      B006DHE Install in this Direction

      Slide in the direction of the arrow shown in the illustration to attach the part (a) at 4 positions and the claw and install the fuel filler opening lid assembly.

    2. Remove the protective tape.

  4. INSTALL REAR WHEEL HOUSE LINER LH

    Tech Tips

    Use the same procedure for the RH and LH sides.

    Click here

  5. INSTALL ROCKER PANEL MOULDING PROTECTOR LH

    Click here

  6. INSTALL REAR TIRE LH

    Click here

  7. INSTALL FUEL LID LOCK WITH MOTOR ASSEMBLY

    Click here