PROPELLER SHAFT ASSEMBLY (for TMT Made) INSTALLATION


  1. INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY (for 2WD)

    A01DXGXE01

    1. Remove SST from the extension housing.

    2. Install the propeller shaft into the extension housing.

    3. A01DXFTE01

      Install the center support bearing bracket with the 2 plates and 2 bolts. Tighten the bolts as much as possible by hand.

    4. A01DXVRE01

      Align the matchmarks on the propeller shaft flange and differential flange.

    5. Install the propeller shaft with the 4 bolts, 4 washers and 4 nuts.

      Torque:
      88 N*m  { 897 kgf*cm, 65 ft.*lbf }
    6. A01DXTIE01

      Unload the vehicle. The center line of the center bearing and center bearing housing (see illustration) must be adjusted to within 0 +-1 mm (0 +-0.04 in.) of each other. Measure the difference along the vehicle front/rear axis.

    7. Tighten the 2 bolts of the center support bearing bracket.

      Torque:
      36 N*m  { 367 kgf*cm, 27 ft.*lbf }

  2. INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY (for 4WD)

    A01E29YE01

    1. Align the matchmarks on the propeller shaft flange and differential flange.

    2. Install the propeller shaft with the 4 bolts, 4 nuts and 4 washers.

      Torque:
      88 N*m  { 897 kgf*cm, 65 ft.*lbf }
    3. A01DXFTE01

      Install the center support bearing bracket with the 2 bolts. Tighten the bolts as much as possible by hand.

    4. Align the matchmarks on the propeller shaft flange and transfer flange.

    5. A01DWWHE01

      Install the propeller shaft with the 4 bolts, 4 washers and 4 nuts.

      Torque:
      88 N*m  { 897 kgf*cm, 65 ft.*lbf }
    6. A01DXTIE01

      Unload the vehicle. The center line of the center bearing and center bearing housing (see illustration) must be adjusted to within 0 +-1 mm (0 +-0.04 in.) of each other. Measure the difference along the vehicle front/rear axis.

    7. Tighten the 2 bolts of the center support bearing bracket.

      Torque:
      36 N*m  { 367 kgf*cm, 26 ft.*lbf }