POWER WINDOW REGULATOR MOTOR(for Hatchback Front Side, Wagon Front Side) INSTALLATION

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for both the RH and LH sides.

  • The procedure described below is for the LH side.

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click hereClick hereClick hereClick here

  2. INSTALL FRONT DOOR WINDOW REGULATOR ASSEMBLY

    Click hereClick here

  3. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

    Click hereClick here

  4. INSTALL FRONT DOOR SERVICE HOLE COVER

    1. Install a new front door service hole cover.

      Click hereClick here

    2. w/ Front No. 1 Speaker:

      1. Connect the connector.

  5. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click hereClick here

  6. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH

    Click hereClick here

  7. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

    Click hereClick here

  8. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Click hereClick here

  9. INSTALL DOOR ASSIST GRIP ASSEMBLY

    Click hereClick here

  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick hereClick hereClick hereClick here

  11. INITIALIZE POWER WINDOW CONTROL SYSTEM

    • for Models with Jam Protection Function on 4 Windows:Click here

    • for Models with Jam Protection Function on Driver Door Window Only:Click here

  12. INSPECT POWER WINDOW OPERATION

    • for Models with Jam Protection Function on 4 Windows:Click here