LIGHTING SYSTEM PRECAUTION

  1. PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.

    System

    See Procedure

    Stop and Start System

    Click hereClick hereClick here

    Power Door Lock Control System

  2. EXPRESSIONS OF IGNITION SWITCH

    The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.

    Expression

    Ignition Switch (Position)

    Engine Switch (Condition)

    Ignition Switch off

    LOCK

    Off (Lock)

    Ignition Switch ACC

    ACC

    On (ACC)

    Ignition Switch ON

    ON

    On (IG)

    Engine Start

    START

    On (Start)

  3. PRECAUTION FOR HEADLIGHT BULB REPLACEMENT

    1. If even a thin film of oil is left on the surface of a halogen bulb, its service life will be shortened because the light will burn at a higher temperature. When replacing a bulb, be sure to hold the flange part of the bulb so that your hand does not contact the glass part of the bulb.

    2. Always prepare a new bulb for immediate replacement. While replacing the bulb, the lens may attract dust and moisture if removed from the vehicle for a long time.

    3. Always replace a bulb with another bulb of the same wattage.

    4. If only replacing the bulb on one side, differences in brightness and lighting color between the right and left sides may occur.

    5. Securely install the socket after bulb replacement. The lens may become cloudy or the light cavity may be filled with water through gaps around the socket if it is not installed securely.