ULTRASONIC SENSOR(for Front) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front ultrasonic sensor removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link

    w/ Parking Support Brake System

  • Ultrasonic sensor (Including removal and installation)

  • Ultrasonic sensor detection angle

  • Ultrasonic sensor detection angle registration

  • Parking support alert system

  • Parking support brake system

Click here


    w/o Parking Support Brake System

  • Ultrasonic sensor (front left sensor, front left center sensor, front right center sensor, front right sensor)

 Initialization of ultrasonic sensors (front left sensor, front left center sensor, front right center sensor, front right sensor) Parking support alert system

Click here

Front bumper assembly (Including removal and installation) Front television camera view adjustment Panoramic view monitor system

Click here

Tech Tips


  • Use the same procedure for the RH and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE FRONT BUMPER ASSEMBLY


    1. for Sport Package:

      Click here

    2. except Sport Package:

      Click here

  2. REMOVE NO. 4 ENGINE ROOM WIRE

    Click here

  3. REMOVE FRONT CORNER ULTRASONIC SENSOR


    1. B006DIO

      Detach the claw and remove the front corner ultrasonic sensor.

      Note

      Before removing the sensor, make sure to mark the sensor and front bumper assembly so that each sensor can be returned to its original position.

  4. REMOVE FRONT CORNER ULTRASONIC SENSOR RETAINER

    Tech Tips

    When removing the front corner ultrasonic sensor retainer, heat the front bumper assembly and front corner ultrasonic sensor retainer using a heat light.


    1. Heat the front bumper assembly and front corner ultrasonic sensor retainer using a heat light.

      CAUTION:


      • Do not touch the heat light and heated parts.

      • Touching the heat light may result in burns.

      • Touching heated parts for a long time may result in burns.

      B006AUBC76
      *a Heated Part
      *b Heat Light
      Standard
      Item Temperature
      Front Bumper Assembly 20 to 30°C (68 to 86°F)
      Front Corner Ultrasonic Sensor Retainer
    2. B006DS4

      Remove the front corner ultrasonic sensor retainer.

  5. REMOVE FRONT CENTER ULTRASONIC SENSOR


    1. B006GQY

      Detach the claw and remove the front center ultrasonic sensor.

      Note

      Before removing the sensor, make sure to mark the sensor and front bumper assembly so that each sensor can be returned to its original position.

  6. REMOVE FRONT ULTRASONIC SENSOR CLIP

    Tech Tips


    • When removing the front ultrasonic sensor clip, heat the front bumper assembly and front ultrasonic sensor clip using a heat light.

    • Use the same procedure for the other front ultrasonic sensor clip.


    1. Heat the front bumper assembly and front ultrasonic sensor clip using a heat light.

      CAUTION:


      • Do not touch the heat light and heated parts.

      • Touching the heat light may result in burns.

      • Touching heated parts for a long time may result in burns.

      B006AUBC76
      *a Heated Part
      *b Heat Light
      Standard
      Item Temperature
      Front Bumper Assembly 20 to 30°C (68 to 86°F)
      Front Ultrasonic Sensor Clip
    2. B006GRZ

      Remove the front ultrasonic sensor clip.