РЕЛЕ СТАРТЕРА ПРОВЕРКА БЕЗ СНЯТИЯ С АВТОМОБИЛЯ


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

  2. REMOVE STARTER RELAY (Marking: ST)


    1. Remove the engine room relay block cover.

    2. Remove the starter relay from the engine room relay block.

  3. INSPECT STARTER RELAY


    1. A01DVNZE26

      Inspect the starter relay resistance.

      Standard resistance
      Terminal Connection Specified Condition
      3 - 5 10 kΩ or higher
      3 - 5

      Below 1 Ω

      (when battery voltage is applied to terminals 1 and 2)

      If the result is not as specified, replace the relay.

  4. INSTALL STARTER RELAY

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

  6. PERFORM INITIALIZATION


    1. Perform initialization Click here.

      Note

      Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.