AIRBAG SYSTEM(w/ Occupant Classification System) DATA LIST / ACTIVE TEST

  1. READ DATA LIST

    Tip:

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / SRS Airbag / Data List.

    5. According to the display on the GTS, read the Data List.

      Body Electrical > SRS Airbag > Data List

      Tester Display

      Measurement Item

      Range

      Normal Condition

      Diagnostic Note

      Left side Buckle SW

      Front seat belt LH

      Unset, Set or NG

      Unset: Front seat belt LH not fastened

      Set: Front seat belt LH fastened

      NG: Data is not determined

      -

      Right side Buckle SW

      Front seat belt RH

      Unset, Set or NG

      Unset: Front seat belt RH not fastened

      Set: Front seat belt RH fastened

      NG: Data is not determined

      -

      Display Type Information

      Display Type Information

      LR

      LR: Display is indicated by LH / RH

      -

      Number of Past DTC

      Number of Past DTCs

      Min.: 0, Max.: 255

      0

      -