SIDE MONITOR SYSTEM(w/ Rear View Monitor System)

DTC Code DTC Name
HOW TO PROCEED WITH TROUBLESHOOTING

CAUTION / NOTICE / HINT

Tip:

  • Use the following procedure to troubleshoot the side monitor system.

  • *: Use the intelligent tester.

PROCEDURE

  1. VEHICLE BROUGHT TO WORKSHOP

    Result

    Proceed to

    NEXT
    NEXT

  2. INSPECT BATTERY VOLTAGE

    1. Measure the voltage with the engine switch off.

      Standard voltage

      11 to 14 V

      If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.

      Result

      Proceed to

      NEXT
    NEXT

  3. CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*

    1. Use the intelligent tester to check if the CAN communication system is functioning normally.

      Result

      Result

      Proceed to

      CAN DTC is not output

      A

      CAN DTC is output

      B
    B

    GO TO CAN COMMUNICATION SYSTEM

    Click here

    A

  4. CHECK COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM*

    1. Use the intelligent tester to check if the LIN communication system is functioning normally.

      Result

      Result

      Proceed to

      LIN DTC is not output

      A

      LIN DTC is output

      B
    B

    GO TO LIN COMMUNICATION SYSTEM

    Click here

    A

  5. CHECK FOR DTC*

    1. Check for DTCs and note any codes that are output.

      Click here

    2. Clear the DTC.

      Click here

    3. Check for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.

      Note:

      The parking assist ECU may store the DTCs of the following system. If DTCs other than those specified in Diagnostic Trouble Code Chart of the side monitor system are output, refer to Diagnostic Trouble Code Chart for the applicable system.

      System

      Proceed to

      Rear View Monitor System (w/ Side Monitor System)

      Click here

      Wide View Front Monitor System

      Click here

      Result

      Result

      Proceed to

      DTC is not output

      A

      DTC is output

      B
    B

    ADJUST, REPAIR OR REPLACEClick here

    A

  6. PROBLEM SYMPTOMS TABLE

    1. Refer to the Problem Symptoms Table.

      Click here

      Result

      Result

      Proceed to

      Fault is not listed in Problem Symptoms Table

      A

      Fault is listed in Problem Symptoms Table

      B
    B

    ADJUST, REPAIR OR REPLACEClick here

    A

  7. OVERALL ANALYSIS AND TROUBLESHOOTING

    1. Refer to Terminals of ECU.

      Click here

      Result

      Proceed to

      NEXT
    NEXT

  8. ADJUST, REPAIR OR REPLACE

    Result

    Proceed to

    NEXT
    NEXT

  9. CONFIRMATION TEST

    Result

    Proceed to

    NEXT
    NEXT

    END