SUSPENSION CONTROL ECU(for AVS) INSTALLATION

PROCEDURE


  1. INSTALL ABSORBER CONTROL ECU

    B006F38

    1. Connect the 2 connectors.

    2. B006EFP

      Install the absorber control ECU with the 2 nuts.

      Torque:
      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

      Note


      • Avoid any impact to the absorber control ECU.

      • Do not drop the absorber control ECU. If it is dropped, replace it with a new one.

  2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Click here

    Note


    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

      Click here

    • After replacing the absorber control ECU, it is necessary to perform registration of vehicle identification information. Vehicle identification information is automatically acquired when the system enters test mode.

      Click here

  3. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY LH

    Click here

  4. ADJUST HEADLIGHT ASSEMBLY

    Click here